Common Emitter Class A Amplifier

In Progress Posted Jan 7, 2010 Paid on delivery
In Progress Paid on delivery

The project is to design and simulate a common emitter Class A amplifier using PSpice.

Nominal preferred values must be used for components and ALL calculations for component values must be shown in detail.

A screenshot is attached of the desired circuit layout which must be adhered to.

Another screenshot is also attached showing the desired output trace, remember midband gain must be 95 and lower and upper frequencies must be 210Hz and 500kHz respectively.

This amplifier will use the BJT Q2N2222 that can be biased using one power supply of 18 volts DC. This amplifier feeds another stage with input impedance of 17k ohms. The amplifier should amplify a signal with frequencies between 210Hz and 500kHz. At the medium frequencies range the output signal is required to be 95 times larger than the input signal which is 7mVrms AC. The collector current at operating point ICq is of 10 mA. Nominal preferred values for components should be used and all calculations for component values must be shown.

Known values are here as shown:

Vin = 7mV rms

Vcc = 18v

Lower cut-off frequency = 210Hz

Higher cut-off frequency = 500kHz

Output impedence (ROUT) = 17k ohms

Vout / Vin = 95

Collector current Icq = 10mA

If you have any questions about this project please message me and I will reply ASAP.

Electrical Engineering Electronics

Project ID: #584934

About the project

10 proposals Remote project Active Jan 8, 2010

10 freelancers are bidding on average $93 for this job

adipdutt

i am enclosing two files of the design, if you are interested, please pay in escrow and i will transfer the value and design guidelines 1 had to put in one cap and one resistor. IC=9.88mA Vc=8.115 peak outp More

$150 USD in 0 days
(3 Reviews)
3.0
jayasundarak

I can do it for you. In fact I make my students do this kind of amplifier design every year for their undergraduate level 3 subjects including the simulation, schematic design and PCB design. I will supply you with a g More

$100 USD in 4 days
(0 Reviews)
0.0
saliah2003

hi; Contact me I can do this for you. Regards

$100 USD in 4 days
(0 Reviews)
0.0
tipu04

Hi i can do this project for in Altium , i can do simulation for it in Pspice with in Altium.

$85 USD in 5 days
(0 Reviews)
0.0
zamroo

I have 8years experience in electronics field. So i can do in any circuit simulation software.

$80 USD in 7 days
(0 Reviews)
0.0
debasis007

I am an Design Engineer for an reputed Semiconductor company having ~3 years experience in Analog and Mixed Signal Design, Layout and Verification.

$100 USD in 2 days
(0 Reviews)
0.0
sumairahmad

Dear, i have work experience with Orcad (PSpice). I already have done similar projects during my studies. I can help you in best way. You will get very good results from here. Thanks

$150 USD in 2 days
(0 Reviews)
0.0
rmilan

Please check Your pm, thanks.

$30 USD in 1 day
(0 Reviews)
0.0
makinmakin

See details in MB.

$60 USD in 2 days
(2 Reviews)
4.5